Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Guardsman Duct Repair & Sealing in Johns Creek: What to Know First
We provide independent Guardsman duct repair and sealing in Johns Creek for homeowners whose duct systems are leaking conditioned air, pulling attic heat, or showing pressure drops that the HVAC unit can’t overcome. Most Guardsman jobs we handle in the Medlock Bridge corridor and surrounding neighborhoods are completed in a single scheduled visit, with a written price delivered before any panel comes off. We are not affiliated with or authorized by Guardsman; we are an independent service provider who works on these systems because they show up in a significant share of the 2015-2022 builds we service.
This page is for Johns Creek homeowners who have a Guardsman air handler, coil cabinet, or packaged unit and need the ductwork connected to it sealed, repaired, or rebuilt. If you are seeing uneven temperatures between floors, utility bills that climb without explanation, or dust streaking around ceiling registers, the problem is often in the duct runs, not the unit itself. Call (470) 326-1926 for a free estimate with a written price.
How Guardsman Products Fail - and How We Fix Them
- Guardsman G-Series air handler plenum separations. The G-Series units installed in many Johns Creek townhomes between 2017 and 2021 use a lighter-gauge plenum connection that can pull away from the cabinet when attic temperatures swing the metal through expansion cycles. We find gaps of 1/4 inch or more at the top seam, which dumps conditioned air directly into the attic. Our fix: remove the old plenum, fabricate a heavier-gauge replacement, and seal with mastic rated for the temperature range.
- Guardsman Flex-Lok flexible duct compression at elbows. The Flex-Lok line uses an internal wire helix that can kink when installers route it through tight chases in two-story homes. In the zoned systems common around Abbotts Bridge Road, we regularly find the first elbow above the air handler crushed to half its diameter. We replace the damaged section with new flex duct sized to the original CFM rating and support it with straps at 4-foot intervals so it cannot sag again.
- Guardsman Rigid-Seal metal duct seam failure. The Rigid-Seal snap-lock seams rely on factory gaskets that harden after five to seven years in Georgia attic heat. We see this most often in homes where the ductwork was installed in 2016 or 2017 and has now passed that gasket life. The fix is not tape; it is breaking down each joint, cleaning the old gasket material, and resealing with mastic and fiberglass mesh for a permanent repair.
- Guardsman Coil-Connect cabinet rust-through at the drain pan interface. The condensate drain on Guardsman coil cabinets can back up if the trap dries out, and the resulting moisture attacks the cabinet base where it meets the return duct. We have found this in Johns Creek homes with seasonal occupancy where the system sits idle for months. We repair or replace the affected cabinet section, install a proper trap primer if needed, and seal the new connection to prevent recurrence.
- Guardsman Zone-Damper actuator linkage wear. The Zone-Damper series uses a plastic linkage between the actuator motor and the damper blade that becomes brittle and cracks. When the damper sticks partially open, one zone overpressurizes while another starves. We replace the linkage with a metal upgrade where available, or replace the entire actuator if Guardsman has superseded the part. We then balance the system and document the pressure readings at each register.
Our Guardsman Duct Repair & Sealing Process

- 1
System inspection with photo documentation. We photograph the condition of every accessible duct run, plenum connection, and register boot before touching anything. The photo goes first. The price comes after.
- 2
Written scope and price, delivered on site. Under Haven Standard Clause 1, we provide a written price for the full scope before any work begins. No per-vent pricing, no add-ons after the fact.
- 3
Parts decision: OEM Guardsman or quality aftermarket. We stock common Guardsman repair parts and will use OEM when it is the right choice. If Guardsman has superseded a part or an aftermarket equivalent meets the specification at lower cost, we explain the trade-off and let the customer decide.
- 4
Repair and seal with documented methods. We use mastic sealant, fiberglass mesh, and mechanical fasteners appropriate to the material. Metal-to-metal joints get mastic and mesh; flex duct connections get proper collars and tension straps.
- 5
Pressure test and airflow verification. We measure static pressure and airflow at the air handler and at representative registers to confirm the repair restored design performance.
- 6
Cleanup, photo record delivery, and written guarantee. The customer receives before-and-after photos of every duct run we touched, plus the written 365-Day Done Right Promise.
Before
AfterWhat Guardsman Duct Repair & Sealing Costs in Johns Creek
| Scenario | Typical Range |
|---|---|
| Single flex duct run replacement (Guardsman Flex-Lok or equivalent) | $340-$580 |
| Plenum repair or replacement (G-Series cabinet connection) | $420-$760 |
| Metal duct seam resealing, per run (Rigid-Seal or equivalent) | $280-$520 |
| Zone damper actuator replacement with rebalancing | $380-$640 |
| Full system seal (mastic, mesh, register boots, pressure test) | $1,200-$2,100 |
What moves the price: accessibility (crawl space vs. walk-up attic), the number of duct runs involved, whether the original Guardsman parts are still available or have been superseded, and the extent of secondary damage from long-term leakage. Every estimate is free, and every price is written and agreed before work starts. Call (470) 326-1926 for an exact quote on your Guardsman system.
Why Johns Creek Homeowners Call CleanRun Air Duct Cleaning Johns Creek for Guardsman Work

We have worked on Guardsman systems in Johns Creek since they started appearing in the new construction boom around 2015. Tomas Reyes and our crew know the specific failure patterns of the G-Series, Flex-Lok, and Rigid-Seal lines because we have photographed them, repaired them, and documented the results under the 365-Day Done Right Promise.
Our technicians are background-checked and uniformed under Haven Standard Clause 3: Verified Crews. We also service Lennox, Trane, and Carrier systems, which matters when a Johns Creek home has mixed equipment or when the original Guardsman component has been superseded by a cross-brand part. Every job includes the Documented Photo Record we have delivered on every visit since 2013. The price is written before work starts. The guarantee is written before we leave.
FAQs
No, properly performed duct sealing or repair does not void the HVAC equipment warranty, though damage caused by improper repair can. We use manufacturer-specified materials and methods, and we document our work with photos so there is a record of what was done and how. If your Guardsman unit is still under factory warranty, we can work with the terms rather than around them. Call (470) 326-1926 to discuss your specific warranty status.
Repair is viable when the damage is localized, the duct material is in sound condition overall, and the original design CFM can be restored. We replace when we find systemic degradation, undersizing that cannot be corrected with repair, or when the cost of multiple repairs approaches replacement. The camera and pressure test tell the difference; we show you both before quoting. Call (470) 326-1926 for a free evaluation.
Guardsman has superseded several parts for pre-2018 systems, and some components are now available only as aftermarket equivalents or cross-brand replacements. We stock the common items and source same-day or next-day for less common parts through our supply network in metro Atlanta. If your system needs a part that is no longer manufactured, we will tell you before quoting and explain the replacement options.
Most single-point repairs, such as a plenum reseal or flex duct replacement, are completed in two to four hours. Full system sealing on a zoned home in Johns Creek typically takes a full day. We schedule the work when it fits your calendar, not with artificial urgency, and we confirm the time estimate in writing with the price.
You receive before-and-after photographs of every duct run we accessed, a written scope of work, and pressure test results showing static pressure and airflow before and after repair. This is standard on every job, not an upgrade. If the numbers do not improve, we do not consider the job complete. Call (470) 326-1926 to schedule a documented repair.
Written by Tomas Reyes, Owner, CleanRun Air Duct Cleaning Johns Creek at CleanRun Air Duct Cleaning Johns Creek, serving Johns Creek and nearby areas.




Before
After
Before
After